Hazards assessed
7
Risk reduction from controls
55%
Still high after controls
0
Job Hazard Analysis (JHA)
Break a task into steps, rate each hazard for severity and likelihood, and record the controls that reduce it.
FormSite Safety & QualityFree
Authorise welding, cutting, grinding and torch work only after fire precautions are checked, with a fire watch and final close-out.
Shown with sample data
Hot work is one of the leading causes of fires in buildings under construction and renovation. This permit follows the approach of NFPA 51B and OSHA 1910.252: it identifies the work, location and people, makes the permit authorising individual confirm each precaution (sprinklers, combustibles cleared within 35 feet, openings covered, extinguisher present, atmosphere tested), assigns a trained fire watch during the work and for at least 60 minutes after, and closes out with a final fire check.
Any work that produces flames, sparks or heat capable of igniting materials: welding, cutting, brazing, soldering, grinding, thermal spraying and torch-applied roofing.
A permit authorising individual (PAI) appointed by the site or facility, trained in hot work hazards, who is not the person doing the work.
Normally for one shift or less, for the specific location and task. New location, new task or a change of conditions means a new permit.
Download a copy
Downloads need a free account.